Adicon xxx

4) Click Controller Utility with your left mouse button. 5) Click Auto Address Modules with your left mouse button. 102The Active light on each module will flash rapidly. Go to each module and press and release the address button. 2) Connect the ADICON™ 2500 Series daisy chain and apply power to each module as described in each module’s manual.

Note: Be sure to write down which modules are programmed as Module 1, Module 2 etc.

104 The Type indicates what module is at the specified address indicated under MOD#.

Version (Vers on the controller access screen) is the software version stored in each module.

13) Re-enter the If the new module is addressed using the second method then CPU parameter 3 must be changed to show the highest module number.

For example, if your system has 6 modules and you replace module 2, then after auto addressing, CPU parameter must be changed to 6.

Search for adicon xxx:

adicon xxx-4adicon xxx-65adicon xxx-42

The number after “Looking for Module” will increment once. 11) Repeat Steps 2-10 for each new module you want to add. 12) Remove power from and Ocelot™ and Module and reconnect the new module in the daisy chain in the desired location and reconnect the other modules to the Ocelot™ or Leopard™.

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “adicon xxx”